null

Diatone Mamba F30 Mini 4in1 ESC 20x20 M2

US$42.00
Write a Review
Diatone Mamba F30 Mini 4in1 ESC 20x20 M2

Specifications:

Output Current: 30 amps
Peak Current: 40 amps
Input Voltage: 2-5 Cell LiPo
BEC: No
Current Detection: Yes
Dimensions: 29x29x5.5mm
Mounting pattern: 20x20mm
Mounting Holes: M2
Firmware: BLHeli_S(CH40)
Input signal: Dshot300 & Dshot600

Includes:

1x Mamba F30 Mini 20x20 M2 4in1 ESC
1x Diagram / spec sheet
1x XT30 connector
1x 25v 330μF cap (see notice below)
1x 3.5cm 8 pin wire harness with twisted power wires
1x 6.5cm 8 pin wire harness, plug on one side, pins on the other side
1x Spare 8pin plug
5x Blue gummy standoff 4mm
8x M2 silicone o-ring
1x Red 16AWG wire 8cm (pre-tinned)
1x Black 16AWG wire 8cm (pre-tinned)
2x Black heat shrink 1cm
4x M2 20mm bolts
4x M3 to M2 washer
8x M2 nylon nuts
4x M2 nylon washers

Notice:

1. If 5S is used, it is recommended to solder the included capacitor.
2. The amperage meter scale needs to be set to 183 for the current sensor to work.

 

Important Note:
Electronics are not warrantied beyond being dead on arrival.
If for whatever reason you have no time to check the electronics within 14 days of receiving them, then no warranty or replacement will be granted.
So please only order this if you have time to check for proper functioning within 14 days of arrival.
Claims for defective parts emailed to us after this 14 days period is up will be denied.