*Important note
This stack is a one and done deal. No re-stocking or after-sale support, hence the low price.
It was soldered up once and test-hovered indoors a few times, basically brand new.
SKYSTARS F722 Flight Controller and ESC 45A Blheli-32 32bit
The ESC has a built in filter capacitor that removes the rear EMF, stabilizes battery voltage and protects components from the ESC to the flight controller.
Note : There is no difference in appearance between 45A and 60A ESC that can be distinguished by the MOS tube.
Flight control :
MCU: STM32F722RGT6 216MHz
Gyroscope: MPU6000
OSD: Betaflight SPI OSD DJI HD OSD (UART6)
Serial interface: UART 1/2/3/4/5/6
BEC: 5V 3A 10V 3A dual channel BEC supports stable DJI sky-side power supply
Input voltage: 3-6S
Black Box: 8MB
Use firmware: SKYSTARS F7HD
LED: 4 independent LED buffers, support WS2812 programming lamp output.
Receiver: Built-in support Sbus, crsf, ibus, Spektrum 1024/2048, SBUS, XBUS, SumD and SumH RX,
Spektrum 3.3v satellite receiver, supports PPM receivers, the default receiver input is UART1, but F7 has a built-in inverter that can actually be installed in any aftermarket UART.
Installation Size: 30.5mm ¡Á30.5mm M4 installation hole without rubber
External size 39mm x 39mm
Flight control weight: 6.9 g
Voltage sensor on board.
45A ESC :
The installation size is 30.5mm x 30.5mm. The installation hole is M4 without rubber
ESC Weight: 12g
ESC on-board current sensor.
Continuous current: 45A
Instantaneous current [5 seconds]: 55A
Training Signal: Dshot300-1200/Proshot1000/Oneshot/Multishot/PWM
MCU: STM32F051 Operating frequency: 48MHz
Firmware: BLheli-32
The MOS tube model is QN3019M6
